Nuevo High Level Front Marker Light

by Alpinerambler Sun Jul 04, 2021 1:35 pm

The nearside Marker LED light is slowly failing, I have locked a spare from JOKON but can't see exactly how to replace the fitting and seal it afterwards. Has anyone done the job.

Thank you

by PLOUGHLIN Sun Jul 04, 2021 1:58 pm

Two screws hold the body to the van. Pull clear, probably short wires. Bulb holder will have copious blob of sealer applied by AS, remove most and holder twists free (120 deg turn?).

When I did it, I sealed holder on with self amalgamating tape OK so far.

by Alpinerambler Sun Jul 04, 2021 4:20 pm

Thank you, Ive order new light, so will try and fit in the next dry spell, are the wired in a connector, new one comes with 250mm wires.

Thank again

by PLOUGHLIN Sun Jul 04, 2021 4:27 pm

Mine had female connectors onto the male bulb holder . May be worth using inline connector with heat shrink onto original wires to ease re-fitting.

by Alpinerambler Sun Jul 04, 2021 4:29 pm

Thank you again, yes I can use heat shrink over the join.

Thank you again, and for the quick response.

Glyn

Nuevo High Level Front Marker Light

Nuevo High Level Front Marker Light

Re: Nuevo High Level Front Marker Light

Re: Nuevo High Level Front Marker Light

Re: Nuevo High Level Front Marker Light

Re: Nuevo High Level Front Marker Light