Sargent 328

I would like to remove the front of my Sargent  328 unit to ckeck my solar panel control unit .does the  unit have to be removed from the wall .or can the front be removed any advice ,tips dos or don'ts.please.

I think the front fixings are at the back (top) and on the bottom surface, so removal is required,

I had to remove my EC328, but it was in a different conversion than yours. You may also find that the cover fixing screws are security Torx - they were on mine.

Removed my EC325 the other week-wires extremely short-so not a lot of movement unless unplugged.

Steve

Thanks for replies,  One of my concerns is the short cables and having enough room to unplug them .I can sea 4 side screws that look like they retain front panel are their more screws on the base that make complete removal necessary . bazz

The 4 side screw down the sides retain the unit to the wall not the front cover.
the cover has 2 top and 2 bottom screws (safety torx with the centre pin).

[You must be registered and logged in to see this link.]